Mazda 6 armatuuri hoiatus tuled põlevad sõidu ajal..

Mazda 6 armatuuri hoiatus tuled põlevad sõidu ajal..

PostitusPostitas merits88 » 21 Veebr 2017, 21:26

selline mure et sai tehtud DPF filtri puhastus aga juhe läks vähe valesse kohta ja nüüd spidokas ei näita ja armatuuris kõik kollased tuled säravad..millega hakkama sain ja kuiadas lahendada...???
merits88
 
Postitusi: 1
Liitunud: 21 Veebr 2017, 21:12

Re: Mazda 6 armatuuri hoiatus tuled põlevad sõidu ajal..

PostitusPostitas arxanyus » 22 Veebr 2017, 12:13

kuidas ee DPF-i "puhastamine" välja nägi???
arxanyus
 
Postitusi: 80
Liitunud: 05 Aug 2016, 15:00

Re: Mazda 6 armatuuri hoiatus tuled põlevad sõidu ajal..

PostitusPostitas justin.keiss » 22 Veebr 2017, 13:22

Kui "juhe läks valesse kohta", siis ilmselt nii:

1. Make sure the engine is warmed up (important).
2. Start the engine.
3. Connect the pin in the red circle to earth (chassis).
4. Press the accelerator to the floor and release 2 times.
5. The engine speed increases, if not got to (2).
6. This process can take up to 60 min and is very hard on the battery.
7. When the engine goes to idle remove the wire to chassis.
8. Let it run for 3 min before turning off.

To stop the cleaning process press the clutch down and put into 1'st gear and
hold until it idles or disconnect the wire. Let it run for 3 min before turning off.

Pilt
Kasutaja avatar
justin.keiss
 
Postitusi: 266
Liitunud: 07 Mär 2015, 02:26


Mine Mazda 6

Kes on foorumil

Kasutajad foorumit lugemas: Registreeritud kasutajaid pole ja 0 külalist

cron