Kui "juhe läks valesse kohta", siis ilmselt nii:
1. Make sure the engine is warmed up (important).
2. Start the engine.
3. Connect the pin in the red circle to earth (chassis).
4. Press the accelerator to the floor and release 2 times.
5. The engine speed increases, if not got to (2).
6. This process can take up to 60 min and is very hard on the battery.
7. When the engine goes to idle remove the wire to chassis.
8. Let it run for 3 min before turning off.
To stop the cleaning process press the clutch down and put into 1'st gear and
hold until it idles or disconnect the wire. Let it run for 3 min before turning off.